立即博

木屑颗粒机批发厂家告诉你影响木屑颗粒机产量的因素

来源:http://www.comicbopk.com 发布时间:2019-07-16 浏览次数:
  影响木屑颗粒机产量的七个因素:
  Seven factors affecting the output of sawdust granulator:
  1、润滑脂增加少量油脂(0.5%~1%),有利于减少颗粒机部件的磨损,并使颗粒容易通过模具孔,增加造粒产值。但是,当增加量超过2%时,颗粒就会松动,难以形成。因此,当增加高剂量的油脂时,建议增加30%的混合机总量和70%的颗粒机总量。
  1. Adding a small amount of grease (0.5%~1%) to the grease can reduce the wear of the parts of the granulator and make the particles pass through the hole of the die easily, so as to increase the value of granulation. However, when the increase is more than 2%, the particles will become loose and difficult to form. Therefore, it is suggested to increase 30% of the total mixer and 70% of the total granulator when increasing the high dose of grease.
  2、适当的粗纤维粗纤维含量(3% ~ 5%),有利于颗粒材料的焊接,减少粉末粒子的速度,增加肉芽输出值,但粗纤维含量超过10%,因为糟糕的粘结,影响粒子的硬度和形成率,增加机械磨损,降低造粒的输出值。
木屑颗粒机批发
  2. Appropriate crude fiber content (3%-5%) is beneficial to the welding of granular materials, reducing the speed of powder particles and increasing the output value of granulation, but crude fiber content is more than 10%, because poor bonding affects the hardness and formation rate of particles, increases mechanical wear and decreases the output value of granulation.
  木屑颗粒机批发
  Wholesale of sawdust granulator
  3、物料含水率过高,降低制粒过程中蒸汽量的增加,影响制粒温度的进展,进而影响颗粒饲料的产值和质量。物料含水率过高,难以调整和质量,容易在环模内壁与压辊之间形成物料滑移,造成环模孔堵塞。一般情况下,淬火回火前材料的含水率应小于13%。
  3. The excessive moisture content of material reduces the increase of steam content during pelletizing process, which affects the progress of pelletizing temperature, and then affects the output value and quality of pellet feed. The material moisture content is too high to adjust and quality. It is easy to form material slip between the inner wall of the ring die and the pressing roller, which results in the blockage of the ring die hole. In general, the moisture content of the material before quenching and tempering should be less than 13%.
  木屑颗粒机批发
  Wholesale of sawdust granulator
  4. 蛋白质材料具有蛋白质含量高、可塑性高、粘度增加、加热后成粒产量高的特点。但是,当非蛋白氮l(如尿素等)较高时,造粒的生产价值降低。
  4. Protein materials have the characteristics of high protein content, high plasticity, high viscosity and high grain yield after heating. However, when the non-protein nitrogen L (such as urea) is higher, the production value of granulation decreases.
  5、淀粉粒淀粉含量高,在高温下,高水分容易成粒,产值高,目前对调理水的要求在16%~18%之间。回火及回火温度应在80℃以上。否则,淀粉糊化程度较差,易发生脆性颗粒,甚至无法形成。如果谷物在调质和回火(如干燥玉米)之前已经成熟,那么制粒价值就会降低。因此,采集的物料也不要选择烘干。
  5. The starch content of starch granules is high. At high temperature, high moisture is easy to granulate and the output value is high. At present, the requirement for conditioning water is between 16% and 18%. Tempering and tempering temperature should be above 80 C. Otherwise, starch gelatinization degree is poor, brittle granules are easy to occur, or even can not be formed. If the grain is ripe before tempering and tempering (e.g. dry corn), the value of granulation will be reduced. Therefore, the material collected should not be dried.
  6. 如乳糖、乳清粉等热敏性饲料,加热后粘度增加,生产价值增加。但当温度超过60℃时,容易出现结焦,堵塞模具孔,影响造粒的生产价值。因此,当调节和回火这种饲料时,可以使用温水。
  6. For heat-sensitive feed such as lactose and whey powder, the viscosity increases after heating, and the production value increases. But when the temperature is over 60 C, it is easy to coke, plug the die hole, and affect the production value of granulation. Therefore, warm water can be used when adjusting and tempering the feed.
  木屑颗粒机批发
  Wholesale of sawdust granulator
  7、无机无机无机饲料几乎没有附着力。造粒功能差影响造粒产值。因此,当无机含量较高时,通常需要向物料中添加少量粘合剂(如糖蜜)来改善造粒功能,提高颗粒机的产值。
  7. Inorganic, inorganic and inorganic feed has almost no adhesion. Poor granulation function affects the output value of granulation. Therefore, when the inorganic content is high, it is usually necessary to add a small amount of binder (such as molasses) to the material to improve the granulation function and increase the output value of the granulator.
  济南龙腾新能源重型设备有限公司多年来专注于生物质颗粒机、木屑颗粒机、秸秆颗粒机等的设计与开发,是济南生物质颗粒机行业较早的生产厂家之一;较强的生产经验和技术实力。公司致力于推动生物质颗粒机系列新能源机械的研发、资源保护,为改善我们的生活环境、改善空气质量、解决煤炭燃料短缺问题开辟了一条新的道路。想要了解更多内容,欢迎访问木屑颗粒机批发网站:http://www.comicbopk.com
  Jinan Longteng New Energy Heavy Equipment Co., Ltd. has been focusing on the design and development of biomass granulator, sawdust granulator and straw granulator for many years. It is one of the earliest manufacturers in Jinan biomass granulator industry. It has strong production experience and technical strength. The company is committed to promoting the research and development of biomass granulator series of new energy machinery, resource protection, to improve our living environment, improve air quality, solve the problem of coal fuel shortage has opened up a new way. For more information, please visit the wholesale website of sawdust granulator: http://www.comicbopk.com

上一篇:秸秆颗粒机厂家告诉你投资生物质秸秆颗粒机设备多少钱

下一篇:判断生物质颗粒机生产厂家实力的提示

大圣棋牌APP下载 麒麟棋牌免费安装下载 大圣棋牌 广东11选5走势图 大圣棋牌官网版下载 广东11选5 广东11选5走势图 大圣棋牌 广东11选5走势图 大圣棋牌