即时比分网

秸稈顆粒機具有高行程以增加產量

來源:http://comicbopk.com 發布時間:2019-12-06 瀏覽次數:
  怎么提高秸稈顆粒機的產量呢?好的秸稈顆粒機是一個非常好的基礎,除了這個之外,只要在相同的條件下,還是有很多可控的因素,在這里和大家分享一下。
秸稈顆粒機廠家
  How to improve the output of straw granulator? A good straw granulator is a very good foundation. In addition to this, as long as there are many controllable factors under the same conditions, I would like to share with you here.
  控制粗纖維材料的含量。 粗纖維是秸稈造粒過程中非常重要的因素。 含量太多,粘結性差,難以壓制成型,含量太小,不利于成型。 通常,對照約為5%。 我們會聯系具體的價值。 我們根據您的具體情況給出計算結果。
  Control the content of crude fiber material. Crude fiber is a very important factor in the process of straw granulation. Too much content, poor adhesion, difficult to press, too small content, not conducive to forming. Generally, the control is about 5%. We will contact specific values. We will give the calculation results according to your specific situation.
  添加油脂。 當秸稈顆粒機用作燃料顆粒機時,需要向材料中加入適量的油,約0.8%。 添加潤滑脂有兩個優點,一是減少機器的磨損,提高機器的使用壽命。 其次,材料變得易于壓制和形成并增加產量。 應該指出的是,控制量不應過多。 添加方法通常是在混合攪拌部分中添加30%,并在造粒機中噴灑70%。 如果你使用秸稈顆粒機制作飼料顆粒,不要,或者你不能吃顆粒狀的動物。
  Add grease. When the straw granulator is used as the fuel granulator, it is necessary to add an appropriate amount of oil to the material, about 0.8%. There are two advantages of adding grease. One is to reduce the wear of the machine and improve the service life of the machine. Second, the material becomes easy to press and form and increases yield. It should be noted that the amount of control should not be excessive. The adding method is usually adding 30% in the mixing and stirring part and spraying 70% in the granulator. If you use a straw granulator to make feed pellets, don't, or you can't eat granulated animals.
  水分控制在13%左右。 對于生物質燃料,應嚴格控制材料的水分。 這是將材料壓成顆粒的前提。 如果水分太高,顆粒會松動。 這不是很多,但請記住。
  The water content should be controlled at about 13%. For biomass fuel, the moisture content of materials should be strictly controlled. This is the premise of pressing materials into particles. If the moisture is too high, the particles will loosen. It's not a lot, but remember.
  如果生物質秸稈顆粒機使用不當,產量將低于標準預期產量。 如果使用時間很長,則產量會下降。 作為生物質木質顆粒的制造商,我們有以下建議。
  If the biomass straw granulator is used improperly, the output will be lower than the standard expected output. If it is used for a long time, the output will decrease. As a manufacturer of biomass wood particles, we have the following suggestions.
  1.調整原料的水分含量。 抑制生物質顆粒所需的鋸末和鋸末等原料的水分含量約為13%。 太高或太低都會降低產量。
  1. Adjust the moisture content of raw materials. The moisture content of sawdust and sawdust is about 13%. Too high or too low will reduce production.
  2.調整顆粒機的參數。 例如,壓力輥和模具之間的間隙。 不同材料需要不同的間隙。 輸出低,可能是間隙未正確調整。 讓制造商調整它。
  2. Adjust the parameters of the granulator. For example, the gap between the pressure roller and the mold. Different materials need different gaps. The output is low, maybe the gap is not adjusted correctly. Let the manufacturer adjust it.
  3.新模具應磨削。 限于秸稈顆粒機的機械制造水平,新模具的模腔平滑度達不到秸稈顆粒機的水平。 研磨方法也很簡單,好多次按壓油,沙和木屑的混合物。 詳細過程可以詢問制造商,或聯系我們的客戶服務。
  3. The new mold should be ground. Limited to the mechanical manufacturing level of straw granulator, the smoothness of new mold cavity can not reach the level of straw granulator. Grinding method is also very simple, many times pressing oil, sand and sawdust mixture. For detailed process, you can ask the manufacturer or contact our customer service.
  4.做好機器維護,及時更換模具。 模具和壓輥秸稈顆粒機需要很長時間才能引起磨損,這是不可避免的。 如果這是生產下降的原因,好更換新模具。
  4. Maintain the machine and replace the mould in time. It takes a long time for mould and press roll straw granulator to cause wear, which is inevitable. If this is the reason of production decline, replace the new mold.

上一篇:生物質顆粒機調節葉片可沿軸線沿兩個方向沿軸線調節

下一篇:最后一頁

重庆彩票 重庆彩票 重庆彩票 上海时时乐 上海时时乐 专业玩彩 专业玩彩 专业玩彩