即时比分网

生物質顆粒機使用中有哪些應注意的問題

來源:http://comicbopk.com 發布時間:2019-11-19 瀏覽次數:
  生物質顆粒機使用中有哪些應注意的問題
  在生物質造粒機的消耗工程中,用戶往往不注意一些小細節,更終形成設備檢修,不僅影響消耗,而且增加成本。下面小編跟隨生物質顆粒機生產廠家大家分享使用中一些注意事項:
  In the consumption engineering of biomass granulator, users often don't pay attention to some small details, and finally form equipment maintenance, which not only affects consumption, but also increases cost. The following editor will share some precautions with the biomass granulator manufacturer:
  1。生物質造粒機停止加工時,為避免壓力損失和環模,不得將金屬物混入待加工粉末中。
  1. When the biomass granulator stops processing, in order to avoid pressure loss and ring mold, it is not allowed to mix metals into the powder to be processed.
  2。待加工粉末的含水量應在13-20%左右,過高會影響成型,過低會引起梗塞的高溫,降低生產能力,也會影響模具壽命。
  2. The moisture content of the powder to be processed should be about 13-20%, too high will affect the molding, too low will cause the high temperature of the infarction, reduce the production capacity, and also affect the mold life.
  3。開機前要檢查生物質造粒機加油機是否正常,油路是否暢通,防止軸承等附件被高溫燒壞。
  3. Before start-up, check whether the fuel dispenser of biomass granulator is normal and whether the oil circuit is unblocked to prevent the bearing and other accessories from being burnt by high temperature.
  4。生物質造粒機停機時,投料速度不宜過快。大約10分鐘后,身體開始發熱,然后可以正常速度進食。否則,會因梗塞引起高溫。生物質顆粒機生產廠家
  4. When the biomass granulator is shut down, the feeding speed should not be too fast. After about 10 minutes, the body starts to heat up and then can eat at a normal rate. Otherwise, it will cause high temperature due to infarction.
  5個。新的環模必須用磨料磨光。具體方法是:用木屑、金剛砂、發動機油按7:2:1的比例配制磨料,從手動進料口反復倒入,約40分鐘。根據生物質造粒機的出料條件和溫度變化,及時調整進料速度。對于初期的排料,常見的粉碎現象較多,顆粒形狀較小,屬于正常現象。幾分鐘后就可以恢復正常了
  5. The new ring mould must be polished with abrasive. The specific method is: use sawdust, Emery and engine oil to prepare abrasives in the proportion of 7:2:1, pour them repeatedly from the manual feed port for about 40 minutes. Adjust the feeding speed in time according to the discharging conditions and temperature changes of biomass granulator. For the initial discharge, the common crushing phenomenon is more, the particle shape is smaller, which is a normal phenomenon. It'll be back to normal in a few minutes
  6。生物質造粒機在運行過程中,應隨時檢查各部位螺栓、螺母和管道的緊固情況,防止松動。必須密切注意這一步驟,以防止螺釘松動,對人體或設備本身造成傷害。
  6. During the operation of biomass granulator, the fastening of bolts, nuts and pipes at all parts shall be checked at any time to prevent loosening. Pay close attention to this step to prevent the screw from loosening and causing injury to human body or equipment itself.
  7。生物質造粒機的電流應按正常負荷控制,絕對不允許長時間超過負荷消耗,這是造成設備損壞的主要原因。在整個過程中,生物質造粒機只有在接近滿負荷運行時才能達到的消耗狀態。
  7. The current of biomass granulator should be controlled according to the normal load, and it is absolutely not allowed to exceed the load consumption for a long time, which is the main cause of equipment damage. In the whole process, the biomass granulator can achieve the best consumption state only when it is close to full load operation.
  8。注意生物質造粒機正常使用時的電流波動,如有異常應停機檢查;
  8. Pay attention to the current fluctuation when the biomass granulator is in normal use, and shut down for inspection in case of any abnormality;
  9。新設備投入使用后,連續更換造粒機傳動箱500小時,然后根據一般消耗情況每3-6個月更換一次機油,100-120工業齒輪油;
  9. After the new equipment is put into use, the pelletizer transmission box shall be changed continuously for 500 hours, and then the oil and 100-120 industrial gear oil shall be changed every 3-6 months according to the general consumption;
  10。生物質顆粒機堵塞時,必須松開壓輥,在清理壓模內壁前重新啟動壓輥。堵轉情況下必須停止強制啟動,不得用管鉗拉齒輪軸。
  10. When the biomass granulator is blocked, the pressing roller must be loosened and restarted before cleaning the inner wall of the pressing die. In case of locked rotor, the forced start must be stopped, and the toothed axle shall not be pulled with pipe tongs.
  11。經常檢查造粒機易損件的磨損情況,防止設備突然失效和環模開裂。
  11. Frequently check the wearing condition of vulnerable parts of pelletizer to prevent sudden failure of equipment and cracking of ring mold.
  通過以上分享,我們希望能對您有所幫助。欲了解更多信息,請訪問comicbopk.com
  Through the above sharing, we hope to help you. For more information, visit comicbopk.com

上一篇:木屑顆粒機批發適用范圍及特點!

下一篇:最后一頁

重庆彩票 重庆彩票 重庆彩票 上海时时乐 上海时时乐 专业玩彩 专业玩彩 专业玩彩